How to repair a Whirlpool washing machine that does not turn (صيانة غسالات دايو)

Your Whirlpool direct drive washing machine has quit spinning. On the off chance that regardless it loads up with water and drains as usual, you should supplant the coupler. It is the most normally supplanted piece of Whirlpool washing machines and, with a little exertion, you can repair it yourself without calling technical help.

Guidelines

Separate the washing machine. Expel the mounting screws from the highest point of the support and open it. It has pivots.

Unplug the wires that go to the top switch and utilize your screwdriver to evacuate the two cinches that associate the bureau to the back of the washer. Tilt the upper part forward and expel it from the washing machine.

Evacuate the two clasps that hold the siphon to the engine, at that point expel the siphon. Separate the wiring tackle from the engine and evacuate the upper and lower clips from that point. Evacuate the engine to get to the coupler.

Supplant the old coupler with another one. Supplant the engine, wiring bridle and siphon.

Supplant the bureau. Make sure to put the base front edge of the bureau under the base of the washer outline first, and after that place the bureau until the tabs on the edge coordinate the openings in it. Make sure to connect the links to the spread once more. Close the reassure and associate the washing machine to test it.(صيانة دايو)